J'ai postulé en ligne. Le processus a pris 2 semaines. J'ai passé un entretien chez One-Cycle Control (Irvine, CA) en févr. 2023
Entretien
The interview process was normal but a little odd. After getting the interview, they asked me to disassemble and reassemble a small mechanical part using some tools. Once finished with that, they sent me up to the interview room where there were very few behavioral questions and instead there were mostly technical questions.
Questions d'entretien [1]
Question 1
Why is a cantilever beam stronger when its height is longer than its width?
J'ai postulé via une autre source. J'ai passé un entretien chez One-Cycle Control
Entretien
They insisted that a new graduate with a BS degree needs to have a PHD as well as a 4.0 GPA which was not listed in the job posting, ultimately wasting time of both parties when a simple check of a resume would have answered the question.
J'ai postulé en ligne. Le processus a pris 1 jour. J'ai passé un entretien chez One-Cycle Control en févr. 2023
Entretien
The interview was in person and I was interviewed by three team members. The interview lasted about three to four hours. First part was going over my resume and was followed by technical questions.
