J'ai postulé via un recruteur. J'ai passé un entretien chez WD (Irvine, CA) en oct. 2012
Entretien
5 engineers comes into the room 1 by 1 for the interview. Same old introduction and resumes and start asking questions on white board. Almost 90% of the questions are about BUCK converters(focus a lot on this). The hiring post online did not show anything useful to prepare for the interview. The interview takes up about 3 hours.
Questions d'entretien [1]
Question 1
Not really difficult but it would be really helpful if you can remember the drawing and calculation and explanation of a BUCK converter
