J'ai postulé via un établissement d'enseignement supérieur ou universitaire. Le processus a pris 1 jour. J'ai passé un entretien chez Arm (Trichy) en août 2013
Entretien
the interview process was on campus at my college, National Institute of Technology Tiruchirappalli.
it started with an initial presentation by the company about the job offer. and then followed by a screening test on electronics, aptitude and software. the selected candidates were called for interview the next day. the interview had two parts, technical interview and HR interview. and finally the results were announced the same day. offer letter was given within a month
Questions d'entretien [1]
Question 1
i was asked questions on verilog and inverter characteristics in the technical interview
J'ai postulé via la recommandation d'un employé. J'ai passé un entretien chez Arm (San Diego, CA) en avr. 2026
Entretien
1st was a hirevue interview - basic behavioral questions
2nd round was a panel interview - discussion on your resume and technical questions related to power and designing low power circuits
Questions d'entretien [1]
Question 1
Given two processors, how would you determine which is better in terms of power (think about frequency, VDD, temperature etc)
Given a boolean logic, how would you reduce power in this
CV and then virtual interview then final interview through online call. It was basic interview about CV and some technical questions. It was not too difficult and intimidating. Technical interview depends on the role you apply for.
Questions d'entretien [1]
Question 1
What was a difficult problem you encountered during your studies and how did you overcome it.
Interview was done online remotely with a manager and a graduate employee. General questions about previous experience and CB. Then followed by a live code session in Arm assembly with various technical questions.
